Welcome to Like Figures!



Profile Informations

Shipping Address


or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Street is required!
City is required!
Postcode is required!
Country required!
Email or Password is wrong!

Flux Vase

More Views

Flux Vase

Availability: In stock

Flux Vase
STL Files


Flux Vase _Designed by AK_Eric ( http://www.thingiverse.com/thing:617395/#files ) _Instruction given by Designer: "-flux_vase.stl : Has no top or bottom. This is what I printed with in Simplify3D since it handles forms like this fine (nice!). _Sliced in Simplify3D & printed on Makerbot Replicator (1) with these settings: 200 micron, 2 shells, no infill, no roof, 4 bottom layers. Natural PLA @ 200 deg, HBP off. No raft, no supports. 90mm/sec print, 120mm/sec travel. Took around 5.25 hours. Note if I printed this again I'd use 3 or 4 shells : While this needs no support, if you want it water-tight you'll need more shells to help the extreme angles for the folds in the middle area."
Additional Information

Additional Information

SKU 10000876
Length [mm] 130.41
Width [mm] 126.95
Height [mm] 190
Volume [cm³] 1179.84
Area [cm²] 1786.91