DetailsPolygonal Necklace _Designed by jcnoguera ( http://www.thingiverse.com/thing:698371/#files ) _Comments written by designer :"Polix is an edgy and bold necklace, here shown printed in two parts out of wonderful carbon-fiber reinforced PLA. It is designed to fit in printbeds down to 6" square in one go. Attach the parts with chain, rope, or whatever you desire or matches your material. -Prints wonderfully in Proto-Pasta Carbon fiber reinforced PLA or in any type of PLA plastic at infill .5 or higher. Support material is suggested although it is possible to print without any with a small loss of quality."
- Additional Information
SKU 10001198 Length [mm] 185 Width [mm] 174.64 Height [mm] 40.16 Volume [cm³] 36.96 Area [cm²] 357.06